- Heti verkkokaupasta ja myymälästä (Aawee Jämsä)Tuotteet lähetetään 1-3 arkipäivässä
- Heti verkkokaupasta ja myymälästä (Aawee Jämsä)Tuotteet lähetetään 1-3 arkipäivässä
- Heti verkkokaupasta ja myymälästä (Aawee Jämsä)Tuotteet lähetetään 1-3 arkipäivässä
Innovatac haulikon makasiinin jousi
Vapaa pituus: LIGHT 1200mm, MEDIUM 1200mm, FACTORY 1250mm
Light for most modern semi-auto competition shotguns with up to 12 shell tube
Medium for most pump-action shotguns with up to 12 shell tube, or increased feed reliability for semi-automatics
Factory rating for pump action shotguns without feed modifications, very long tubes and increased reliability for all platforms when dirty or other problems with feeding
High quality steel spring wire with color marker (spring steel not colored, as in the picture)
Instructions:
Remove any color/power markers or packaging material from the spring
Assemble spring to the magazine tube and fully compress it 4-5 times (fill the magazine full of shells)
Spring will take some set and shorten approx 40-90mm
Cut the spring to preferred length, after the spring has taken a set
You can always leave the spring longer than recommended minimum, this will add reliability
Tube length = total magazine tube length from the receiver shell latch to the end of the magazine extension tube
Example recommendations for typical magazine tubes:
Recommended minimum for Light in 12 shell tube: tube length + 350mm (no need to cut)
Recommended minimum for Light in 10 shell tube: tube length + 300mm
Recommended minimum for Medium in 12 shell tube: tube length + 250mm
Recommended minimum for Medium in 10 shell tube: tube length + 200mm
Recommended minimum for Factory in 14 shell tube: tube length + 250mm
Recommended minimum for Factory in 12 shell tube: tube length + 200mm
Make sure your magazine tube and follower is clean and smooth
Always test the functionality of your setup in training
